Configuring ingress mappings
You can modify the ingress mappings to change traffic priorities. However, as a best practice, use the default mappings.
Procedure
Variable Definitions
Use the data in the following table to use the qos ingressmap command.
Variable |
Value |
---|---|
1p <0-7> <0-6> |
Maps the IEEE 802.1p bit to QoS level. Each QoS level has a default
IEEE 1P value:
default qos ingressmap 1p |
ds <0-63> <0-6> |
Maps the DS byte to QoS level. The system reserves level 7 for Network Control. To use the default configuration, use the default option in the command: default qos ingressmap ds |